Idiomas disponibles
Idiomas disponibles
Fixing screw
of the solder direction tube
Cartridge
Solder direction tube
*
Changing the handpiece's cartridge
¡¡Warning!
As a safety measure and in order to avoid burns,
when the cartridge is manipulated you must switch
off the station or disconnect the solder feed
handpiece. Take into account that it only takes a
few seconds to reach the working temperature.
With the JBC system, the cartridge can be changed
quickly. Here is what to do to change the cartridge:
1 Loose the fixed cartridge screw you will find
in the handle. Release the cartridge.
1
2 Place the cartridge in the solder feed handle.
2
Trigger
Cartridge screw
Alignment
Solder reel
Ref.0552315
* Use the attached solder direction tube ref. 0006559 for long cartridges
Important.
-
It is essential to insert the cartridge till the
end for a good connection. Take the mark
as reference.
3 You must leave a distance between 8-10mm
from the tip of the cartridge and the end of the
guide tube end. Tighten the screw of the guide
tube.
3
Guide tube
8 - 10 mm
Guide tube screw
4 Direct the tip of the cartridge over the solder
guide tube exit. Tighten the cartridge screw.
4
WARNING: It is esential to tighten this screw for the
tool to function.
2
ENGLISH
Cartridge
and electric
connection
screw
