Drilling; Led Working Light; Chuck Replacement; Maintenance And Environmental Protection - I-DRILL 2i-drill Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Drilling

Drilling metals
Always clamp sheet metal.
Support thin metal with a block of wood to avoid
distorting it.
Use a punch to mark the centre of the hole.
Use a suitable lubricant for the material you are
GB
working on,
USE:
FOR:
Oil
Steel
Turpentine or paraffin
Aluminium
Do not lubricate
Brass, copper or cast iron
Drilling plastics and plastic coated chipboard
Use high speed drill bits
See drilling wood below
Drilling masonry
This drill is not designed for drilling masonry. Purchase
or hire a Hammer drill.
Drilling wood
Clamp a piece of scrap wood to the back of your work to
prevent splintering.
All drilling operations
Mark off the centre of the hole using a centre punch or nail.
Don't force the drill, let it work at its own pace
Keep the drill bit sharp.
Reduce pressure, as the drill is about to break through
the item being drilled.

LED working light

When the unit is switched on, the LED working light (11)
also comes on to ensure better vision and to make working
in dark areas more safe. The working light goes out when
the On/Off switch is released.
CAUTION!
LED is laser class 1! Do not look directly into the
laser as this may result in damage to the eyes.
Rechargeable battery charge display (12).
If the on/off switch is pressed, the rechargeable battery
display indicates the charging status of the rechargeable
battery:
3 LEDs light up:
The rechargeable battery is fully charged
2 LEDs light up:
The rechargeable battery is half charged
1 LED lights up:
Charging of the rechargeable battery
required

Chuck replacement

The chucks of reversible drills are always fixed by a screw
with a left-hand thread. The screw, which is located in the
centre of the chuck, must be removed before the chuck can
be removed. To remove the screw, turn it in a clockwise
direction. The chuck can now be removed by unscrewing it
anti-clockwise. If you have trouble removing the chuck take
the drill to your nearest authorised service centre for chuck
replacement.
CAUTION.
Always ensure that the drill is switched off
and the battery pack is removed before making any
adjustments.

Maintenance and environmental protection

Clean the case only with a damp cloth – Do not use
solvents! Then dry well. To maintain capacity, we
recommend completely discharging and recharging the
battery every two months. Store only fully charged batteries.
They should therefore be recharged from time to time. The
place of storage must be dry; the ambient temperature must
not fall below 0 °C (32°f) for rise above 40 °C (104°f).
16
CAUTION!
Electrical and battery operated units that no
longer work should not be disposed of in the household
waste! They are to be collected separately, in accordance
with the 2002/96 EC directive for the disposal of
electrical and electronic waste, and sent for proper and
environmentally friendly recycling.
ATTENTION!
Batteries must be removed from battery-
powered tools and disposed of separately in accordance
with relevant wastebattery regulations. Batteries must never
be disposed of with domestic waste!
Please discard power tools no longer usable at a local
collection point. Collection and disposal of packaging
materials separately by types complying with local rules
and regulations. For details, please contact your municipal
authority concerned.

Service instructions

Store the machine, operating instructions and where
necessary the accessories in the original packaging. In this
way you will always have all the information and parts ready
to hand.
For any other information contact us via www.i-drill.com
17
GB
Tabla de contenido
loading

Tabla de contenido