Component List; Technical Data - Worx WX030 Manual Original

COMPONENT LIST

1. VACUUM TUBE
2. ON-OFF SWITCH
3. SOFT THIN BRUSH STORAGE PORT
4. DUSTING BUTTON
5. FLAT TOP BRUSH STORAGE PORT
6. BATTERY PACK
7. DUST CUP BOTTOM COVER
8. SOFT THIN BRUSH
9. FLAT TOP BRUSH
Some of the accessories mentioned in
illustrations or texts are not included in the
scope of supply.

TECHNICAL DATA

Rated Voltage
Maximum idle
6
speed
Charge time
Machine weight
ACCESSORIES
Battery
pack(WA3551)
Battery
pack(WA3551.1)
Charger(WA3880)
Soft thin brush
Flat top brush
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
Vacuum Cleaner
WX030 WX030.1 WX030.9
20V
34000r/min
1hr
1.8kg 1.8kg
WX030 WX030.1 WX030.9
1 /
/ 1
1 1
1 1
1 1
OPERATION INSTRUCTION
Note: Please read the instructions
carefully before use.
INSTALLATION AND OPERATION
1. INSTALLATION OF THE SOFT THIN BRUSH/
FLAT TOP BRUSH
Remove the soft thin brush/flat top brush from the
soft thin brush storage port/flat top brush storage
port, connect the vacuum tube and clamp it in place.
(See figure A)
2. START/STOP(SEE FIGURE B)
Press the on-off switch to start the machine and start
the dust absorption operation.
When the switch is pressed for the first time, the
machine starts and works at low speed.
When the switch is pressed again, the machine
works at high speed.
When the switch is pressed for the third time, the
machine stops.
WARNING: PLEASE KEEP THE AIR INTAKE
UNOBSTRUCTED, OTHERWISE IT MAY CAUSE
MOTOR OVERHEATING AND MAY DAMAGE
THE MACHINE.
3. DUST CUP CLEANING
Press the dusting button, and the bottom cover
of the dust cup will pop up automatically. Rotate
counterclockwise and take out the filter element of
the dust cup. (See Fig. C1, C2) Dump the dust and
garbage in the cup and filter element into the trash
can, and rinse the filter element of the dust cup with
1.4kg
clean water. After the filter element of the dust cup
dries naturally, rotate clockwise and lock the filter
element of the dust cup in place.
Warning: Do not use the machine without
installing the filter element of the dust cup.
When the suction of the machine obviously
decreases, it is necessary to clean up the
garbage in the dust cup in time.
/
MAINTENANCE
WARNING: Remove the battery before carrying out
/
any servicing or maintenance.
Never use water or chemical cleaners to clean your
/
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
1
ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the
1
ventilation slots, this is normal and will not damage
your power tool.
OPERATION INSTRUCTIONS FOR THE
ACCESSORIES
Flat top brush is suitable for dust removal from
inaccessible corners in the interior of the car, such
as the bottom of the seat, the side of the seat, the
EN