Programming Track Numbers; Playing A Cassette; Cassette Recorder - Philips MAGNAVOX AZ 1025 Manual Del Usuario

CD PLAYER
2. To return to normal playback press the respective SHUFFLE or
REPEAT control until the various SHUFFLE/REPEAT modes are
no longer shown in the display.
• You can also press STOP 9 to cancel your play mode.

PROGRAMMING TRACK NUMBERS

Program in the STOP position and store your CD tracks in any
desired sequence. If you like, store any track more than once. Up to
20 tracks can be stored in the memory.
™ When the program memory is full, FULL appears in the
display and it will not be possible to add further tracks.
1. Use the CD SEARCH controls ( ∞ or § , ¡ or ™) to select
your desired track number.
2. Press PROG.
™ The display shows
' ' appears briefly.
3. Repeat steps 1 and 2 to select and store all desired tracks.
4. Press PLAY•PAUSE 2; to start playback of your program.
Reviewing your program
• To review your set program, keep PROG pressed for a few
seconds.
™ The display will show in sequence all your stored track
numbers.
Erasing a program
You can erase the contents of the memory by:
– pressing STOP 9 twice;
– opening the CD door;
– moving the CD TUNER TAPE/

CASSETTE RECORDER

PLAYING A CASSETTE

1. Adjust the CD TUNER TAPE/
2. Press STOP•OPEN 9/ to open the cassette holder.
3. Insert a cassette and close the cassette holder.
4. Press PLAY 1 to start playback.
5. To interrupt playback press PAUSE ;. To resume, press the key
again.
6. By pressing the deck SEARCH 5 or 6 keys, fast winding of
the tape is possible in both directions.
To stop fast winding, press STOP•OPEN 9/.
7. To stop the tape, press STOP•OPEN 9/.
™ The keys are automatically released at the end of the tape,
except if PAUSE ; has been activated.
8. To switch off the set make sure the cassette keys are released.
and the track number;
PROGRAM
slider.
OFF
slider to TAPE/
OFF
CASSETTE RECORDER
PROGRAM
position.
OFF
TUNER
CD
13