Idiomas disponibles
Idiomas disponibles
- A belt should not be used if there is a foreseeable risk that the user will be suspended or exposed
to uncontrolled tension by the belt. It may be necessary to supplement work positioning or restraint
systems with fall protection devices of a collective (e. g. safety net) or individual type (fall arrest systems
according to EN 363).
- It is recommended that this product be given individually to a single user.
- Only a person who is trained and competent, or one who is under the surveillance of such a person,
may use this product.
- Ensure that before and during use, a rescue plan has been developed and is understood, so that any
intervention can be carried out effectively and safely.
DESCRIPTION (#2A - #2B - #2C1 - #2C2):
These fall-arrest harnesses are classified as personal protective equipment (PPE) for falling from heights,
and are compliant with the EN 361:2002 standard.
When a work positioning belt is integrated to a harness (ref NUSL4ECO) it complies to standard
EN358:2018 to ensure a restraint work position and prevent a fall.
Their configuration and free size guarantee a comfort of use and complete safety. The size of the belt
is from 75 to 130 cm.
This full body harnesses (including work positioning belt) are manufactured using 44 mm wide
polyester straps, sewed to each other and connected by metal fastening and adjustment buckles.
The fall arrest attachment points are identified by the «A» or «A/2» markings (dorsal attachment
point and sternal attachment point). Any unidentified ring «A» or «A/2» cannot be used as a fall arrest
attachment point.
If the harness integrates a work positioning belt, the lateral attachment points without identification are
intended only for work positioning (EN 358 : 2018).
WEARING THE HARNESS (#3):
1 : Hold the harness by its dorsal hooking point and disentangle the straps if required.
2 : Slip on the shoulder straps one after the other, like a jacket, without twisting the straps.
3 : Buckle and adjust the chest strap as appropriate.
4 and 5 : Buckle and adjust each leg strap after positioning them at the crotch (#4).
(Fastening flat buckles #4) :
1. Lengthen
2. Shorten
6 : For the model including a work positioning belt (ref NUSL4ECO) fasten and adjust the belt adjusting
strap (#4).
The full body harness with belt is correctly adjusted if :
- All of the straps are correctly adjusted (neither too tight nor too loose), they do not cross each other
and are not twisted.
- The dorsal hooking ring is correctly positioned in line with the shoulder blades.
- The chest strap is correctly positioned in the middle of the chest.
- The ends of all of the straps are held in the elastic strap loops.
VERIFICATIONS :
- If there is any doubt on the reliability of the equipment, do not use it without getting the written
authorisation of a person who is authorised to decide on its reuse.
- When setting up the fall-arrest system with other safety components, verify the compatibility of each
of the components and ensure that all of the recommendations in the product instructions and the
applicable standards pertaining to the fall-arrest system are applied. - In particular, ensure that no safety
function of any component is affected by the safety function of another component and that they do
not interfere with each other.
- The belt is approved for a user, including their tools and equipment, for a weight up to 140 kg.
- A person weighing 140kg or less can use this harness if the associated fall arrest systems meet the
normative requirements of stopping a fall with a mass of at least 140 kg.
