Safety Instructions - cecotec FAST&FURIOUS 4040 ABSOLUTE Manual De Instrucciones

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
All safety instructions should be closely followed when using
the appliance.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the wall outlet is
grounded.
If the cord is damaged, it must be replaced by the official
Technical Support Service of Cecotec in order to avoid any type
of danger.
Do not immerse the cord, plug, or any non-removable part
of the appliance in water or any other liquid, nor expose the
electrical connections to water. Make sure your hands are dry
before handling the plug or switching on the appliance.
If the appliance falls accidentally in water, unplug it immediately.
Do not reach into the water!
Do not twist, bend, strain, or damage the power cord in any
way. Protect it from sharp edges and heat sources. Do not let
it touch hot surfaces. Do not let the cord hang over the edge of
the surface.
This appliance is not intended to be operated by means of an
external timer or separate remote-control system.
Turn off and unplug the appliance from the mains supply when
not in use and before cleaning it. Pull from the plug, not the
cord, to disconnect it from the outlet.
This appliance is designed to iron textiles. It is designed for
domestic use only and, therefore, not suitable for commercial
use. Do not use outdoors.
To protect against burns or injuries to persons, do not iron
textiles while being worn on the body.
Do not use any accessory that has not been recommended by
Cecotec, as they might cause injuries or damage.
Place the appliance on a dry, stable, flat, heat-
resistant surface.
The temperature of accessible surfaces may be high
while in use and could cause burns. Do not touch hot
surfaces while in use or immediately after.
Do not aim steam at people or animals and do not iron clothes
directly on the body to avoid risk of burns.
Do not leave the product unsupervised during operation.
Unplug the device after use and when you leave the room
where it is installed.
Do not use the device when the water tank is empty.
Do not allow the power cord to come into contact with high-
temperature steam during product operation.
Remove the power plug before cleaning the product, installing
or removing brush accessories, or filling the water tank. Allow
the device to cool down for 60 minutes after use before cleaning
it.
The use of tap water is recommended. If the lime content of the
tap water is too high, use a mix composed of 50 % of tap water
and 50 % of water with low mineral content. Do not use only
water with low mineral content.
To protect against burns or injuries, do not direct steam toward
persons or animals when ironing.
Do not use the device with perfume, vinegar or other liquids.
This product is designed to operate only with water.
Do not try to repair the device by yourself. Contact the official
Technical Support Service of Cecotec for advice.
Cleaning and maintenance must be carried out according to
this instruction manual to make sure the appliance functions
properly. Turn off and unplug the appliance before moving and
cleaning it. Make sure the iron has completely cooled down