Tabla de contenido
Idiomas disponibles
Idiomas disponibles
This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼" blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 9). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
s
e t
p
s
h
a
v
e
b
e
e
n
c
o
m
p
e l
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 16)
Hanger Bracket
Assembly
Fan Motor
Assembly
• One wire stripper
• Four wire connectors
(supplied)
Unpacking Instructions
e t
d
a
n
d
w
l l i
b
e
h
l e
f p
l u
n i
Ceiling Canopy
Switch Housing
Assembly
Canopy Screw Cover
Assembly
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
n i f
d
n i
g
y
o
r u
p
a l
c
e
s
h
o
u
d l
•
Fan Motor Assembly
•
Hanger Bracket Assembly
•
Ball Downrod Assembly
•
Canopy
•
Canopy Screw Cover Assembly
•
Motor Coupling Cover Assembly
•
Switch Housing Assembly
•
Blade Holder Set
•
Blade Set
•
TR34 Remote Hand Held
Motor Coupling Cover
Assembly
Blade Holder Set
Blade Set
4
Materials
Wire Size A.W.G.
Up to 50 ft.
50 - 100 ft.
y
o
u
b
e
i
t n
r e
u r
p
e t
. d
• Hardware bag:
– Eleven ¼"-20 x ½"
(blade holder to fan motor hub)
screws with lockwashers
– Sixteen
to blade holder) washer-head
screws with fiber washers
– Phillips Screwdriver 4"
– Three wire connectors
– Threaded Plug
– Balance Kit
– Safety Cable Bag Assembly
Ball Downrod
Assembly
14
12
3
/
-24 x 7.5mm (blade
16
TR34
Remote Hand Held
Hardware Bag
Capítulos
Tabla de contenido
Solución de problemas
