How To Assemble Your Light Kit Or Cap - Fanimation STELLAR MAD7998 Serie Manual Del Usuario

How to Assemble Your Light Kit or Cap

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Remove the three screws in the light kit and
retain the screws for later. (Figure 3)
5A. For use with light kit.
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
NOTE: If you have installed your fan with the steel
cap, skip Steps 6 and 7.
Motor Assembly
Light Kit
Light Kit
Light Kit
Wire Cover
LED Assembly
Figure 5A
12
Figure 1
Figure 2
Figure 3
Light Kit
Figure 4
Light Kit
Figure 5B
Steel Cap