Tait TM81 Serie Guía Del Usario página 34

Removing the control head
Caution:
1
2
32 Radio installation
During this procedure, take care that the control-
head seal is not damaged. Damage to this seal
reduces environmental protection.
On the underside of the radio, insert a 5mm (3/16 inch)
flat-bladed screwdriver between the control head and the
control-head seal, in either position
Insertion points
cated on the radio chassis by a dot-dash-dot
–
pattern (• •).
1
Use the screwdriver to lift the control head off the chassis
clip, then repeat in the other position.
The control head can now be removed from the radio body.
2
1
and are lever points and are indi-
2
1
2
2
or .
2
1
lever point
control-head seal
indication of
lever point