Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Step Four
·
Re-align brackets with holes and secure using screws.
·
Align the square hole in the retention strap with the hole in the top bracket and attach the retention
staps between the top bracket an the wall. Make sure each strap is aligned with and secured to a stud.
screw
NOTE: You may need to drill an extra hole in the top bracket to mount the retention strap to a
wall stud. Safety strap usage is for seismic purposes. Regulations may vary by region.
Doc # 81815 | Rev B | Page 8 of 32
retention strap
Step Five
·
Lower brackets on back of the Sans board onto brackets on wall.
·
IMPORTANT: Always check to insure both top and bottom panel brackets are resting on the wall
Doc # 81815 | Rev B | Page 9 of 32
NOTE: The top and bottom of the board can be
easily identified by locating the branded logo.
Notice the logo is applied to the bottom right
hand side of the panel.
NOTE: Consider using glass suction cups when
mounting panel.
Tabla de contenido
