System Connections; Connecting / Disconnecting The Om-Gryphon Interface Cable - Datalogic Om-Gryphon Serie Manual De Instalación Rápida

English

SYSTEM CONNECTIONS

Connections should always be made with power OFF!
You can connect the OM-GRYPHON cradle to the Host through the dedicated
connector, using the cable corresponding to the desired interface type.
CONNECTING / DISCONNECTING THE OM-GRYPHON
INTERFACE CABLE
The OM-GRYPHON can be connected to a Host by means of an RS232,
Wedge or Pen emulation cable which must be simply plugged into the Host
connector, placed on the base of the cradle. In addition the cradle must be
connected to an external power supply, see the figure below.
Host Interface
Cable
To disconnect the cable, insert a paper clip or other similar object into the hole
corresponding to the Host connector on the body of the cradle. Push down on
the clip while unplugging the cable. Refer to the following figure:
4
CAUTION
Figure 1 – OM-GRYPHON - Bottom view
Figure 2 – OM-GRYPHON - Disconnecting the cable.
Power Supply