brilli 20752-000 Instrucciones Importantes De Seguridad página 4

INSTALLATION (DIRECT-WIRE METHOD - CONVERTIBLE)
1. Loosen the screw ① with a Phillips screw driver (not included).
(See Fig.6).
Fig.6
2. Remove Direct-Wire Cavity Access Plate ②. Determine
appropriate knockout for removal in relationship to incoming
Romex (power supply).
TO REMOVE KNOCKOUTS:
Place a standard screwdriver (not included) on edge of circle (on
opposite side from retaining tabs) and gently strike with hammer.
Grip edge with pliers and flex back and forth until removed (See
Fig. 7).
Fig.7
3. Push supply cable through the Romex Bushing ⑨. Strip black
and white wire leads with wire strippers to expose 3/8"-7/16" of
bare metal (See Fig.8). If wiring is being routed through the
knockout on the Direct-Wire Cavity Access Plate ②, install
Romex Bushing ⑨ into the access plate (See Fig.8). Insert and
secure the supply cable by tighten the screws on Romex Bushing.
(See Fig.8). Secure the Direct-Wire Cavity Access Plate ② onto
the fixture assembly.
A
D
NOTE：When install the hex nut, make sure the small step (A
side) facing the Cavity Access Plate ②, and the D part is parallel
with the plate, not vertical (see Fig.8). After the hex nut is
tightened, make sure its B side is parallel with the plate's C side
(see Fig.9).
Fig.9
C
B
WARNING: RISK OF ELECTRICAL SHOCK
• Do not use 5' power cord accessory when also direct-wiring
the fixture! Use only one method to power the fixture.
4. Loosen the screws and take down the backboard (See Fig.10).
Fig.10
Fig.8
For Customer Assistance:
www.evolutionlightingllc.com
Made In China
5. Pull the wires with the wire terminals and connect with the input
cord from the conduit (see Fig.11). Insert the white supply wire
(neutral) into wire terminals
wire.Insert the black supply wire (hot) into wire terminals
preassembled black fixture wire. Insert supply ground wire into wire
terminals with the preassembled fixture ground wire.
Fig.11
6. Put the wires in order inside of the under cabinet, put on
backboard and screw up (See Fig.12).
Fig.12
7. Position the fixture housing against the mounting surface and
with a pencil, mark the screw hole locations to be located at the
narrow section of the keyholes (See Fig.1).
Fig.1
8. Using a drill with a 1/8" drill bit (not included), make two small
pilot holes at the marked locations. (Note: do not drill entirely
through mounting surface).
9. Partially install the provided mounting screws ⑦ with a Phillips
screwdriver (not included).
10. Position the keyhole mounting holes over the screw heads and
slide the fixture until the screw heads are over the narrow section
of the keyholes. Finish tightening the screws to secure the fixture.
11. If using only one fixture skip to Step 12. If connecting more
fixtures, please follow steps 7-10. WARNING: Do not link
together more than six units of fixtures on any single run.
Note: The distance between fixtures cannot exceed the length of
the included 13" connector cord ⑩ (See Fig.2) or end-to-end row
connector ⑧ (See Fig.3).
To route your fixtures around a corner, simply install a fixture near
the corner and route the 13" connector cord
to connect the next fixture.
Fig.2
Fig.3
12. Turn on power at the circuit breaker box and verify that fixture
functions properly. If fixture does not turn on, verify that the rocker
switch on each fixture is in the "on" position.
4
with the preassembled white fixture
around the corner
⑩
with the