Safety Information - brilli 20752-000 Instrucciones Importantes De Seguridad

SAFETY INFORMATION

Please read and understand the entire manual before attempting to assemble, operate or
install the product.
WARNING
WARNING: RISK OF ELECTRICAL SHOCK
• Do not use 5' power cord accessory when also direct-wiring the fixture! Use only one method to
power the fixture.
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and
any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION: RISK OF INJURY
• Account for small parts and destroy packing material, as these may be hazardous to children.
WARNING: RISK OF BURN
• Allow fixture to cool before handling. Do not touch enclosure or light source.
• Do not exceed maximum wattage marked on luminaire label.
CAUTION: RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• Minimum 90° C supply conductors.
• ELECTRICAL CONNECTIONS (Required Supply Circuit: 120Vac, 60Hz)
• This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
< Reorient or relocate the receiving antenna.
< Increase the separation between the lighting unit and receiver.
< Connect the lighting unit into an outlet on a circuit other than the outlet which the receiver is
connected.
< Consult the dealer or an experienced radio/TV technician for help.
NOTE: Please note that changes and modifcations not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
For Customer Assistance:
www.evolutionlightingllc.com
Made In China
2
•