Shindaiwa P231 Manual Del Propietario - Operador página 7

Assembly
Prior to assembly
Using Figure above as a guide, familiar-
ize yourself with the Shindaiwa P231
pole pruner and its various components.
Understanding your unit helps ensure
top performance, longer service life, and
safer operation.
Before assembling, make sure you have
all the components required for a com-
plete unit:
Powerhead Installation
1. Place the powerhead on a clean, flat
surface, spark plug facing up.
2. Use the 4mm hex wrench to loosen
the tube clamp screw. Verify that the
D-shaped shim washer is positioned as
shown below.
Tube Clamp
Hex
Wrench
3. Add some moly-type EP grease to
splines at the end of the main shaft.
Connecting the Throttle Cable
Remove The Cylinder Cover
1. Remove the spark plug boot.
2. Remove the two lower cylinder cover
screws.
3. Loosen the top cylinder cover screw
until the cover is free of the engine. (The
top cylinder cover screw is captive). Lift
the cylinder cover off of the engine.
■
Powerhead Assembly
■
Lower Tube Assembly
■
Upper Tube/Saw Assembly, Chain and
Guide Bar
■
Chain CoverTool Kit Containing:
Spark Plug Wrench
•
4mm Hex Wrench
•
8 x 10mm Spanner
•
Carefully inspect all components for damage.
CAUTION!
Do not force the shaft tube into
the powerhead! Excessive force
can damage the shaft tube and
mainshaft.
4. Slide the outer tube into the tube clamp
until the tube bottoms. If installation
is difficult, rotate the outer tube or
main shaft slightly until you feel the
mainshaft splines engage with the
powerhead. Outer tube needs to be
inserted so that the end of the grip hits
joint cap.
5. Position the outer tube so that the igni-
tion switch is facing up and the throttle
lever is facing down.
Hex Wrench
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front"
and "rear" refer to directions as viewed by
the operator during normal operation.
WARNING!
Do not make unauthorized
modifications or alterations to your
pruner or its components.
Bar and Chain Options
8 inch Bar — 90SG-33E Chain
10 inch Bar — 90SG-39E Chain
12 inch Bar — 90SG-44E Chain
6. Slide the outer tube into the powerhead
until the throttle grip just contacts the
tube clamp.
7. Tighten the clamp screw firmly.
Tube
Main
Clamp
Shaft
Outer
Tube
Ignition Grip
Switch
Throttle Lever
Top Cylinder
Cover Screw
Spark Plug
Boot
Lower Cylinder
Cover Screws
Clamp Screw
7