Installation - Home Depot GLACIER BAY 5318WWHD Guía De Uso Y Cuidado

[Heading goes here]

Installation

8
Attaching the wall cleat to the wall
NOTE: Before cutting, drilling, or hammering into any wall
surface, verify the location of electrical, plumbing, and gas
lines. Cutting any of these may cause serious injury.
□ In the desired location place the unit against the wall. Make
sure the unit is level and lightly draw a horizontal line where
the top panel (A) meets the wall.
□ Measure down from that line approximately 3.5 in. and, using
a level, lightly draw a horizontal line that is approximately 12 in.
□ Line the top of the wall cleat (F) with that line and, making
sure the wall cleat (F) is level, mark the location on the wall
through the mounting holes.
□ Drill holes in the marked spots on the wall. Note, if the
mounting screws (OO) will not be going directly into studs,
insert the wall anchors (PP).
□ Mount the wall cleat (F) to the wall, using the mounting
screws (OO), as shown.
measure down
approximately 3.5 in.
OO
top of unit mark
PP
F
approximately
3.5 in. down
top of
wall cleat (F)
OO
14
F
PP