Troubleshooting - Toro Powervac 51988 Manual Del Operador

Troubleshooting

PROBLEM
Engine fails to start. 1. No fuel in tank.
2. Spark plug shorted or fouled.
3. Spark plug is broken (cracked porcelain
4. Ignition lead wire shorted, broken, or
5. Ignition inoperative.
Engine hard to start. 1. Water in gasoline or stale fuel mixture.
2. Too much oil in fuel mixture.
3. Engine is under or over-choked.
4. Weak spark at spark plug.
Engine lacks power. 1. Air filter clogged.
2. Spark plug fouled.
3. Spark arrestor/muffler/exhaust port de-
Engine overheats.
1. Insufficient oil in fuel mixture.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the
Maintenance section. It is recommended that you retain all receipts covering maintenance on your equipment.
Neglecting or failing to perform the required maintenance may increase emissions, decrease fuel efficiency,
degrade performance, cause irreversible engine damage and/or void your warranty.
Troubleshooting
POSSIBLE CAUSE
or electrodes broken).
disconnected from spark plug.
posits.
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment to ensure
1. Fill tank with fresh fuel/oil mixture.
2. Replace spark plug.
3. Replace spark plug.
4. Replace lead wire or attach to spark plug.
5. Contact a qualified service center.
1. Drain entire system and refill with fresh fuel/oil
mixture.
2. Drain and refill with correct fresh fuel/oil
mixture.
3. Adjust choke as necessary.
4. Contact a qualified service center.
1. Clean/replace the air filter.
2. Replace the spark plug.
3. Clean/replace spark arrestor /muffler parts as
required.
1. Mix fuel and oil as described in starting
instructions.
CALL US FIRST
call the Toro Help Line!
®
your complete satisfaction.
SOLUTION
21