Assembly Diagram; Troubleshooting; Product Maintenance - HAMPTON BAY 383-586 Manual De Instrucciones

ASSEMBLY DIAGRAM

Fig.2
TROUBLE SHOOTING:
Problem
Light Bulb will not illuminate.
Fuse blows or circuit breaker trips when
light bulb is illuminated.

PRODUCT MAINTENANCE:

1. Turn off power to the light fixture.
2. To clean the outside or inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the
fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never use a solvent) to wipe the inside glass
and interior surface of the fixture. Allow the fixture to dry completely before power is restored.
CAUTION: Do not use chemical solvents or harsh abrasives to clean fixture as damage to the fixture or various components may occur
remedying the fixture inoperable.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from date of
purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service. If this product is
found to be defective, the manufacturer's only obligation, and your exclusive remedy, is the repair or replacement of the product at the
manufacturer's discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or
mishandling. This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in
accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident,
misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty
shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The
manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than
the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental
loss or damage, including but not limited to any labor/expense costs involved in the replacement or repair of said product.
NOTICE:
1. CONNECTOR IS DESIGNED TO LOCK INTO
TRACK SECTION BY TURNING CONNECTOR
IN ONE DIRECTION ONLY.
2. TURN"GROUND INDICATOR"TAB TOWARDS
THE GROUND GROOVE ON TRACK TO ALIGN
GROUND TAB WITH GROUND CONDUCTOR.
Fig.1
Possible Cause
1. Light bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Crossed wires or power wire is grounding out.
Fig.3
Corrective Action
1. Replace light bulb.
2. Make sure power supply is on.
3. Check wiring.
4. Test or replace switch.
Check wire connections.
4
Fig.4