Maintenance - Senix CSPE6.5-M Manual Del Operador

When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
To avoid serious personal injury, always stop the motor
and allow it to cool before cleaning or maintaining the
unit. Never perform cleaning or maintenance while
the unit is running. Disconnect the spark plug wire to
prevent the unit from starting accidentally.
WARNING:
Wear protective clothing and observe all safety
instructions to prevent serious personal injury.
CLEANING
Use a small brush to clean the outside of the unit. Do
not use strong detergents. Household cleaners that
contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic. Wipe
off any moisture with a soft cloth.
Correct and regular cleaning is not only important for
the safe use of this product, but also extends its life
span.
REPLACING THE SAW CHAIN AND CHAIN
BAR
WARNING:
Only use replacement bar/chain combination listed. DO
NOT use any other bar/chain combination.
WARNING:
When handling saw chains, always wear protective
gloves.
Guide bar: 8 inch (203 mm), 080SDEA041, Oregon
Saw chain: 8 inch (203 mm), 91PJ033X, Oregon
Replace chain when cutters are too worn to sharpen or
when chain breaks. Only use replacement chain noted
in this manual. Always include new drive sprocket when
replacing chain. This will maintain proper driving of
chain.
1. Place the saw body on a firm and level surface.
2. Using the supplied wrench, turn the chain sprocket
cover nut counter-clockwise to loosen it. Remove the
nut and cover.
14

MAINTENANCE

Chain Cover Nut
Internal Bolt
Sprocket
3. Wearing protective gloves, wrap the saw chain around
the chain bar, making sure that the teeth are aimed in
the direction of rotation. The chain should be properly
set in the slot running along the entire outside edge of
the chain bar.
4. Place the saw chain around the sprocket while lining
up the slot in the chain bar with the internal bolt at
the base of the saw and the chain tensioning pin in
the chain bar's pin hole. The chain tensioning pin may
need adjustment to properly align with the hole in the
chain bar. Use a flat-blade screwdriver to turn the
chain tensioning screw to adjust the location of the pin
until it fits in the chain bar.
5. Turn the chain tensioning screw clockwise to
preliminarily tighten the chain bar enough that it stays
in place. While holding the bar still, place the cover
back onto the saw. Make sure the tab properly lines
up with the slot on the body of the saw.
Cover
6. Install the collar and locking bolt. Using the supplied
wrench, turn the locking nut clockwise to tighten it. DO
NOT overtighten. Adjust the chain tension.
Chain Tensioning Pin
Chain
Tensioning
Screw
Chain Tensioning
Screw
Locking Nut/
Step Washer
Wrench
WWW.SENIXTOOLS.COM