Switch On/Off; Continuous Operation; Changing Saw Blade - Promaker PRO-SC800 Manual De Usuario

in power tools that have the switch on
invites accidents.
•Remove any adjusting key or wrench
before turning the power tool on.
A wrench or a key left attached to a
rotating part of the power tool may
result in personal injury.
•After switch off, do not braket he
saw blade to a stop by applying side
pressure.
•Use only sharp, flawless saw blades.
Replace immediately cracked, bent or
dull saw blades.
•Changing of blade and shoe must be
done after pull the mains plug.
•Blade must be fitted firmly in the blade
locking equipment. Regularly check if
blade is fitted firmly.
•When sawing, the complete surface
of the base plate should securely rest
on the material.
•Hazardous dust for human health
can smudge by cutting concrete
with asbestos. Take care of legal
regulations and manufacturer advice.
OPERATING
Always use the correct supply
voltage.
The voltage of the power source must
agree with the value given on the
nameplate of the machine.

CHANGING SAW BLADE

Before any work on the machine itself,
pull the mains plug.
•To fit the blade, rotate the blade
locking collar in clockwise direction.
•Slide the blade into the locating
groove with teeth pointing forward.
Ensure the blade rollaer guide is in
contact with the back edge of the
cutting blade at all times.
•Release the locking collar to secure
the blade.
•Universal blade locking equipment is
available for all saw blades in market.

SWITCH ON/OFF

Switching on: Press the on- off
switch.
Switching off: Release the on- off
switch.

CONTINUOUS OPERATION

Push the variable speed switch
trigger and at the same time push
the continuous operation lock
button.
The stop continuous
push variable speed switch and then
release.
STROKE SELECTING
With the thumbwheel, the required
stroke rate can be selected(also while
running).
I - 2 : Low stroke rate
3 - 4 : Medium stroke rate
5 - 6 : High stroke rate
operating,
4