Daily Maintenance - lamber F92-EK Normas Para El Usuario

CLEANING AND PREVENTIVE
MAINTENANCE
PRECAUTION AND CLEANING
INSTRUCTIONS
IMPORTANT: Before carrying out the
-
cleaning and
disconnect the equipment from the mains
power supply.
- High temperatures can be reached inside
the machine (90°C). After power supply has
been removed, wait until the machine has
reached room temperature, before working
on it.
- Never leave tools, parts or other loose
material on the machine or inside of it.
- BEFORE starting machine or cycle, after
any maintenance or repair work, make sure
all protective are correctly installed.
POSSIBLE TROUBLES - CAUSES - SOLUTIONS
PROBLEMS CAUSES
The machine doesn't catch
The water doesn't go in
Insufficient Washing
Insufficient Rinsing
The lamp "D" is flashing
maintenance operations,
Main switch is switched off
Water cock closed
The Overflow is not in place
Wrong detergent or insufficient
dosage
Low temperature in the tank
Dirty wash filter
Rinsing nozzles blocked
Hydraulic pressure lower than
1 bar - 100 kPa
Salt exhausted
quickly
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE

DAILY MAINTENANCE

- Disconnect the machine by pressing the
main switch "A";
- Remove the
water drain out of the tank (look at the
specific paragraph at the preceding
page);
- Wait untill all water is drained and there
are no wastes on the tank bottom;
- Disconnect the machine from the supply
mains by the wall switch;
- Take the filters out and clean them under
running water;
- Re-assemble the removed parts in their
housing;
- Check and clean the washing and the
rinsing jets;
- Clean the outer surface of the machine by
using a wet sponge; do not use water jets
because, besides being dangerous, they
could damage the electrical parts; do not
use abrasive detergents;
- When the machine is to remain unused
for a long time, it's better to perform
the operation
sanification.
- To avoid bad smells, leave the door open.
NEVER WASH THE EXTERNAL
THE MACHINE WITH A WATER JET
SOLUTIONS
Turn ON the main switch
Open water cock
Reassemble the Overflow in
place
Use anti-foam detergent in the
right dosage and never with
cold water
Wait until the water gets hot
Clean filter
Unscrew and clean nozzles
under running water
Wait until the pressure is on or
buy a booster pump
A
dd salt in the container
(see page 22)
23
overflow pipe and let the
od descaling
PART
and
OF