Worx WG117 Manual Del Usuario página 9

the risk of disconnection of appliance cord
from the extension cord during operating:
i) Make a knot as shown in Figure 1;
ii) Use one of the plug-receptacle retaining
straps or connectors described in this
manual.
Table 1 Minimum gauge for extension
cords
Volts Total length of cord in feet
120V 25
240V 50
Ampere Rating
More than Not
more than
0-6 18
6-10 18
10-12 16
12-16 14
NoTE-Only the applicable parts of the Table
need to be included. For instance, a 120-
volt product need not include the240-volt
heading.
Figure 1
METHod oF SECuRING ExTENSIoN
CoRd
APPLIANCe CORD
CORD
seT
(A) TIe CORD As sHOWN
(B) CONNeCT PLUG AND ReCePTACLe
j) avoid unintentional starting. Don't carry
plugged-in appliance with finger on switch.
Be sure switch is off when plugging in.
k) don't abuse cord. Never carry appliance
by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil, and
sharp edges.
2-in-1 Grass Trimmer/Edger
50 100 150
100 200 300
AWG
16 16 12
16 14 12
16 14 12
Not
12
recommended
l) don't grasp the exposed cutting
blades or cutting edges when picking
up or holding the appliance.
m) don't force appliance. It will do the job
better and with less likelihood of a risk of
injury at the rate for which it was designed.
n) don't overreach. Keep proper footing
and balance at all times.
o) Stay alert. Watch what you are doing. Use
common sense. Do not operate appliance
when you are tired.
p) disconnect appliance. Disconnect the
appliance from the power supply when not
in use, before servicing, when changing
accessories such as blades, and the like.
q) Store idle appliances indoors. When not
in use, appliances should be stored indoors
in dry, and high or locked-up place, out of
reach of children.
r) Maintain appliance with care. Keep
cutting edge sharp and clean for best
performance and to reduce the risk of
injury. Follow instructions for lubricating
and changing accessories. Inspect
appliance cord periodically, and if
damaged, have it repaired by an authorized
service facility. Inspect extension cords
periodically and replace if damaged. Keep
handles dry, clean, and free from oil and
grease.
s) Check damaged parts. Before further
use of the appliance, a guard or other
part that is damaged, the tool should be
carefully checked to determine that it will
operate properly and perform its intended
function. Check for alignment of moving
parts, binding of moving parts, breakage of
parts, mounting, and any other condition
that may affect its operation. A guard
or other part that is damaged should
be properly repaired or replaced by an
authorized service center unless indicated
elsewhere in this manual.
3. EdGER-TRIMMERS
a) keep guards in place and in working
order.
b) keep blades sharp.
c) keep hands and feet away from
cutting area.
9
EN