Melchioni Family HOTTY Manual De Usuario página 7

19) Do not use multiple sockets but only sockets with single output with specific power.
20) Always disconnect the plug when the appliance is not in use and before cleaning it. Do not pull the power
cord to turn off the product.
21) Do not fix safety switches with adhesive tape, due to fire hazard.
22) Do not use the product if the power cable is damaged, or following damage to the equipment. In these
cases, have it replaced by competent personnel.
23) Do not let the power cord come into contact with any hot surface.
24) Do not place the cable under other objects. Do not cover the cord with rugs, towels or similar objects.
Do not step on the cable or place it in contact with heat sources.
25) Avoid the use of extensions that could cause the appliance to overheat.
26) This product is for home use and not for commercial or industrial uses. Do not use outdoors.
27) Keep the product clean. Do not allow any object to enter the air outlet parts as it may cause electric
shock, fire or damage to the appliance. Do not insert your fingers into the air outlet grille.
28) Warning: to avoid overheating, never cover or obstruct the heater and / or air intakes.
29) It is absolutely forbidden to disassemble or repair the appliance due to the danger of electric shock, if
necessary contact the retailer or a specialized technician.
30) In the event of anomalous situations, immediately switch off the appliance and contact the retailer or a
specialized technician
HOW TO USE
The fan heater incorporates a rotation switch you can select the different air by turning the switch clockwise to:
0 OFF
COOL AIR
I WARM AIR (1000W)
II WARM AIR (2000W)
When the heater is switched on.
Turn the thermostat knob in a clockwise direction to the max. position.
Once the room temperature has reached the desired temperature, turn the thermostat knob slowly in an anti-clockwise
direction until a "click" sound and that is the setting temperature. Now, the convector is switched off and the indicator
lights off. The heater will automatically maintain the set temperature. It will switch on when the room temperature is
below and switch off it above the setting. The red indicator show that convector is switched on.
INSTALLATION
The article does not require installation, it must be used exclusively as a portable device. Portable devices are not
suitable for use in the bathroom or in wet rooms.
SECURITY DEVICE
To avoid damage and danger due to overheating, the appliance is equipped with a protection device that stops the fan
heater immediately in case of overheating and until the temperature drops below a safety threshold
To deactivate the safety device switch off the appliance and unplug it until it gets cold (about 10 minutes).Plug it again
and switch it on.
If the appliance is still off plug it and bring it to our after sale service.