Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A. INPUT CHANNEL SECTION
1. MIC
Each mono input channel offers a balanced microphone input via the XLR
connector and also features switchable +48 V phantom power supply for
condenser microphones. The preamps provide undistorted and noise-free gain
as is typically known only from costly outboard preamps.
2. LINE IN
Each mono input also features a balanced line input on a 1/4" connector.
Unbalanced devices (mono jacks) can also be connected to these inputs.
3. LOW CUT
The mono channels of the mixing consoles have a high-slope LOW CUT filter
for eliminating unwanted, low-frequency signal components (75 Hz, 18
dB/octave).
4. GAIN
Use the GAIN control to adjust the input gain. This control should always be
turned fully counterclockwise whenever you connect or disconnect a signal
source to one of the inputs.
5. HIGH
The HI control in the EQ section controls the high frequency range of the respective
channel. It is a shelving-type filter which can boost or cut all frequencies a fixed
frequency (12 kHz).
6. MID
The MID control allows you to raise or lower the mid-range level. It is a semi-
parametric peak filter, which boosts or cuts the frequency range around a variable
mid-range frequency.(2.5kHz).
7. LOW
The LOW control boosts or cuts the low-frequency range. Like the HI filter it is
a shelving-type filter, which raises or lowers the level of all frequencies below a
specific frequency (80Hz).
8. AUX1 (MON)
In the FX, aux send 1 can be switched pre-fader and is thus particularly suitable
for setting up monitor mixes. The first aux send is labeled MON and is permanently
switched pre-fader.
MM 804/1204/1604 E USB
3
User manual/Manual de Uso
ENGLISH
1
1
MIC
2
BAL
OR
UNBAL
LINE IN
LOW CUT
3
75 Hz
18 dB/0ct
4
+10
+10
—40
+60
GAIN
EQ
0
HIGH
5
12 KHz
-15
+15
0
MID
6
2.5 KHz
-15
+15
0
LOW
7
80 Hz
-15
+15
0
AUX
1
8
-
+15
Tabla de contenido
