Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Use the TAPE OUT jacks to connect, for example, a tape deck for recording applications.
6
Use the PHONES jack to connect a commercially available pair of headphones.
7
These are the balanced 1/4
8
power amplifier.
Connect the EFF SEND connector to the input of an external effects device.
9
The AUX SEND connector provides the monitor signal of your machine, for example, to control a
10
monitor amplifier or active monitor speaker.
1.2.2 Front panel
11
The GAIN MIC control determines the channels input gain, both for a microphone connected via the
XLR jack and for other signal sources connected to the 1/4 jack.
12
Use the PAN control to adjust the signal s positon on the stereo basis.
13
Your machine comes with a 3-band equalize
control can be used to boost/cut the midrange
lower the gain of the bass range.
14
Use the AUX control to determine the channel volume sent to the
left, the channel volume in the
15
The CHANNEL fader adjusts the volume of the corresponding channel
16
The EFF control adjusts the effects volume for the corresponding channel.
1.2.3 Main section
17
Use this switch to activate the phantom power required for condenser microphones.
18
The LEVEL DISPLAY reads the output level of your machine. Make sure that the two Clip
light up.
This is used for adjusting frequency of echo repeat. Since too much echo repeat may cause a howl.
19
Please adjust frequency properly.
This is used for adjusting the time interval of echo repeat. The middle position position (5) may be most
20
effective
21
The PHONES control governs the headphones volume.
22
The AUX SEND control adjusts the volume level of the
23
The EFF SEND control allows you to adjust the level that is sent to an external effects device
via connector
9
24
Use the MASTER fader to set the overall volume level of your machine.
2. WIRING
MAX 4.2, 6.2, 8.2
' jack MAIN OUTPUTS of your machine that can be used to drice, e.g.a
AUX mix is zero.
.Thus, youcandrive all types of effects devices without any risk of distortion.
Fig. 2.1: Various connector types
User Manual/Manual de uso
r. the HI control govems the high frequen
frequen cies, and the LOW control allows you to raise or
AUX mix bus. When set fully to the
AUX signal provided at connector
cy range, the MID
LED swont
10
.
Pag. 3
EN
Tabla de contenido
