Idiomas disponibles
Idiomas disponibles
6
INSTALLATION INSTRUCTIONS U-HANDLE COMBO KIT
14A. Connect ignition leads (A) and (B).
PAS-210/211, SRM-210/211i/U/SB,SRM-2400/2400SB
Only
14B. Connect jumper lead (O) spade terminal end to power head ignition
lead (A). Install black wire holder (P) and ground lead (Q) on clutch
case with bolt (C). Connect female (O) and male (Q) ignition leads
to male and female lead from throttle linkage.
15A. Remove left side clutch case bolt (R). Install metal bracket clamp
(S) with curved end up. Install throttle linkage into bracket clamp
and pinch tight with pliers. Bend bracket up and flush against drive
shaft.
PAS-210/211, SRM-210/211i/U/SB,SRM-2400/2400SB
Only
15B. Remove left side clutch case bolt (R). Install metal bracket clamp
(S) with curved end down. Install throttle linkage into bracket
clamp and pinch tight with pliers.
16A. Install air filter and cover.
PAS-210/211, SRM-210/211i/U/SB,SRM-2400/2400SB
A
B
A
O
Q
C
R
S
R
S
P
