Idiomas disponibles
Idiomas disponibles
4
INSTALLATION INSTRUCTIONS U-HANDLE COMBO KIT
INSTALLING OPTIONAL U
Tools Required: 8mm x 10mm Open End Wrench, Slotted Screwdriver,
3mm and 4mm Hex Wrench, Scrench, Locking Tool,
Pliers.
Install U-Handle
1.
Close choke and remove air filter cover.
2A. Disconnect ignition stop leads (A) and (B).
PAS-210/211, SRM-210/211i/U/SB,SRM-2400/2400SB
Only
2B. Disconnect ignition stop lead (A). Remove bolt (C) and ground
lead.
3.
Remove inner throttle linkage from carburetor swivel (D).
4.
Remove throttle linkage (E) from throttle linkage fixture (F).
5A. Loosen bolt (G) and pull drive shaft assembly from clutch case.
PAS-210/211, SRM-210/211i/U/SB,SRM-2400/2400SB
Only
5B. Loosen two (2) bolts (G) and pull drive shaft assembly from clutch
case.
6.
Loosen two (2) rear handle screws (H) and pull rear handle (I) from
the drive shaft assembly.
7.
Loosen four (4) screws and remove front handle (J).
-
HANDLE
F
E
A
B
D
E
C
A
F
I
H
J
I
J
D
G
G
H
