GYS GYSDUCTION AUTO Manual Del Usuario página 18

Translation of the original instructions
PRODUCT START UP
3
INDUCTOR DESCRIPTION & USE
All operations described below require practice. GYS recommend experimenting by carrying out
tests on sheet metal or write-off.
Glass inductor
ref. 053373
Description
This inductor is specifically designed to strip off the anti-gravel protection from the lower part of the car body. It can
also be used to remove bonded glass (rear glass, rear quarter, panoramic roof, etc.).
Automatic mode is particularly recommended for removing glass.
Removing glass
◊ Preparation
1. Remove any exterior trim beforehand: For mouldings that cannot be removed, heat the bond from the inside.
2. It is recommended that you also remove any interior trim and components such as clips and studs that may be used
to hold the glass in place.
3. Disconnect aerials and glass defrost circuits.
4. Apply protective tape around the glass to prevent damage to the painted surfaces during handling.
5. Apply protective tape on the glass inductor to avoid scratching the glass. Replace the adhesive tape after each glass
removal.
6. Thoroughly clean the glass before starting the removal process.
18
GYSDUCTION AUTO
1
2
Switch on the station (1)
Accessory connection (2)
1. Select the required inductor.
2. Lift the valve on the Gysduction connector.
3. Connect the inductor connector to the Gysduction.
4. Close the valve to lock the connection.
5. The display shows the number of the connected accessory (eg.
AC1)
Connection of the control pedal (3)
The Gysduction can be supplied with a control pedal (ref. 055490),
necessary for the use of the bolt, adhesive and spiral inductors.
Connect the cable to the Gysduction and the pedal to make it
work.
Heating activation
The glass and dent pulling inductors are fitted with a heating but-
ton. The three other ones work with the control pedal.
Bring the inductor close to the metal part to be heated, then press
the inductor button or the control pedal to activate the heating.
EN