Functions Description; Dry Ironing - Punktal PK-810PL Manual De Producto

4. HOW TO FILL WITH WATER
Make sure the iron is turned off and the AC Power Cord is unplugged from the
Ÿ
electrical outlet.
Turn the steam control to
Ÿ
MIN position. Let the iron rest on the heel.
Fill the water through the filling opening into the water tank，Using beaker
Ÿ
provided, Pour water up to the "MAX" Line on the tank.
The water level can be observed through the transparent part of the tank, when
Ÿ
iron placed vertically. When the water level becomes low, refill the tank,
following the procedure described in steps 1 to 3 above.
If the water is very hard, it is advised to use distilled water or demineralised
Ÿ
water only. Do not use scented water, vinegar or ironing aids in the water tank,
this may cause brown spitting and staining.
Pour out the remaining water after use.
Ÿ
NOTE:
Most tap water can be used in this iron. Do not use water additives or substitute
water such as linen or scented water in the steam iron, they can stain fabrics or
damage the iron. Do not fill the water more than the "MAX" position.

5. FUNCTIONS DESCRIPTION

Dry ironing:

Position the iron vertically. Turn the steam control to
Ÿ
temperature control to the suitable position, plug in the iron, Preheat the iron
until the indicator light goes out, you can start dry ironing.
Spraying:
Before using the spray feature, check the fabric label for ironing instructions
Ÿ
because some fabrics may be spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and
Ÿ
where extra dampening is needed.
The spray may be used with steam or dry ironing.
Ÿ
Ensure that water tank is at least 1/4 full. Simply pump the spray button, Mist will
Ÿ
be sprayed out from the spraying nozzle.
OFF position and temperature Control Dial to the
11
OFF position, set the