Maxon M-14-30 Manual De Instrucciones página 8

NOTE: Taillight modifi cation must be completed before Liftgate is installed so that taillight
bulbs can be replaced without removing liftgate.
1. Remove 2 original taillight screws from
RH taillight lens (FIG. 8-1). These
screws are not needed after the tail-
light mounting is changed.
2. Drill a 9/64" hole through RH taillight
lens and internal sheet metal (FIG. 8-1).
Then, carefully drill a 3/16" hole through
taillight lens to create clearance for the
screw threads (FIG. 8-1).
NOTE: If liftgate is C2-15 model (1500
lb capacity), wait until liftgate
is mounted on pickup bed be-
fore reinstalling taillights.
3. Apply clear automotive silicone seal-
ant (not supplied) to the 3/16" hole in
the taillight lens, and on the threaded
portion of the self-tapping screw (FIG.
8-1).
4. Insert a self-tapping screw (Kit item)
into 9/64" hole to secure the taillight
lenses in place (FIG 8-1). Do not over-
tighten screw.
5. Repeat steps 1 through 4 for LH tail-
light lens.
LIFT CORPORATION Sht. 8 of 38 DSG#
CHANGING TAILLIGHT MOUNTING
M-14-30
ORIGINAL
TAILLIGHT
SCREWS
MODIFYING TAILLIGHT MOUNTING
FIG. 8-1
Rev. C Date: 12/12/17
RH TAILLIGHT
LENS
DRILLED 9/64"
THRU-HOLE &
3/16" HOLE FOR
CLEARANCE
SELF-TAPPING
SCREW