Nice Mindy A500 Instrucciones Y Advertencias Para El Instalador página 2

Mindy A500
Index:
1 Description of the product
2 Installation instructions
2.1 Input voltage selection
2.2 Wiring diagram
2.3 Description of connections
2.4 Notes about connections
3 Testing
4 Adjustments
5 Obstacle adjustment system
Introduction:
This manual has been especially written for use by technical personnel
qualified to carry out installation. No information given in this manual can
be considered as being of interest to end users! This manual is enclosed
with control unit A500 and may not be used for different products!
Important notice:
The A500 control unit has been designed to control an electromechani-
cal actuator for automating gates or doors. Any other use is considered
improper and is consequently forbidden by current laws.
May we remind you that the automation system you are about to
install is classified as "building a machine" and therefore enters the field
of application of European directive 89/392 EEC (machine directive).
This directive includes the following prescriptions:
-Only trained and qualified personnel should install the equipment
-The installer must first perform the "risk analysis" of the machine
-The equipment must be correctly and professionally installed in compli-
ance with all relevant standards.
-After installation, the machine owner must be issued with the "declara-
tion of conformity".
This product may only be installed and serviced by qualified personnel,
therefore, in compliance with current laws, standards or directives.
When designing and producing its products, Nice observes all applica-
ble standards (please see the attached declaration of conformity) but it
is of paramount importance that installers continue to strictly observe the
same standards when installing the system.
!
Unqualified personnel or those who are unaware of the standards
applicable to the "automatic gates and doors" category may not install
systems under any circumstances
! Whoever ignores such standards will be held responsible for any
damage caused by the system!
2
6 Operating modes
7 Programming
7.1 Programmable functions
7.2 Description of functions
8 Using 2 central units on opposite wings
9 Accessories
10 Maintenance
10.1 Environmental protection measures
10.2 Technical specifications
!
Do not install the unit before you have read all the instructions thor-
oughly!
Particular warnings concerning the suitable use of this product in relation
to the 73/23/EEC "Low Voltage" Directive and subsequent modification
93/68/EEC:
- This product responds to the provisions foreseen by the "Low Voltage"
Directive if used in the configurations foreseen in this instructions manu-
al and in combination with the articles present in the Nice S.p.a. product
catalogue. If the product is not used in configurations or is used with oth-
er products that have not been foreseen, the requirements may not be
guaranteed; the use of the product is prohibited in these situation until
the correspondence with the requirements foreseen by the directive
have been verified by installers.
Particular warnings concerning the suitable use of this product in relation
to the 89/336/EEC "Electromagnetic Compatibility" Directive and subse-
quent modifications 92/31/EEC and 93/68/EEC:
- This product has been subjected to tests regarding the electromag-
netic compatibility in the most critical of use conditions, in the configu-
rations foreseen in this instructions manual and in combination with arti-
cles present in the Nice S.p.A. product catalogue. The electromagnetic
compatibility may not be guaranteed if used in configurations or with
other products that have not been foreseen the use of the product is
prohibited in these situations until the correspondence to the require-
ments foreseen by the directive have been verified by those performing
the installation.