Tabla de contenido
Idiomas disponibles
Idiomas disponibles
18. INSTALL THE BLOWER (INTERIOR BLOWER)
Install (4) n°. 8 x 3/8'' screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten
screws down fully, leave a 1/8" gap. Hang blower unit onto blower plate (screws through the large part of the keyhole). Slide the
blower to its position (screws in the small part of the keyhole). Tighten the (4) screws.
HD0044
Single blower (P5)
Secure the blower by installing 2 more n°. 8 x 3/8'' screws for the P5 blower and 4 more n°. 8 x 3/8'' screws for P8 into the locations
shown in the pictures below (single blower or dual blower). Reinstall impeller(s) and cover.
HD0080
Single blower (P5)
FOR DUAL BLOWER UNIT, MAKE SURE THE
IMPELLERS ARE CORRECTLY INSTALLED, THE
INSERT WILL NOT WORK PROPERLY IF
REVERSED.
Both impellers are different in the dual blower, one
rotates clockwise and the other counterclockwise.
Each wheel and motor have an arrow and a number
on them, you have to match them correctly (see
drawing beside).
Never plug the 2-prong blower cord to the 3-prong power supply cord.
Plug the power supply to the 3-prong male connector (A) and the blower unit into
the 2-prong female receptacle (B) inside the insert.
(CONT'D)
HD0045
Dual blower (P8)
HD0081
Dual blower (P8)
1
HD0023
WARNING
!
- 11 -
FRONT
A
B
HE0022
2
Tabla de contenido
