In The Event Of A Power Failure; Preparing To Move; Replacing The Light Bulb - GE GWS0 Manual Del Propietario Y Instalación

Care and cleaning.

Replacing the light bulb.

WARNING
Before replacing a burned-out light bulb, the refrigerator should be unplugged in order to avoid contact with a
live wire filament. (A burned-out light bulb may break when being replaced.)
Turning the control to the OFF position does not remove power to the light circuit.
Light Shield
Screw

In the Event of a Power Failure

If the power fails, open the door as
infrequently as possible to maintain the
temperature. A gradual rise in temperature
should not have any adverse effect on the
wine.
If it is extremely hot, you may want to unload
the wine from the beverage center/wine
chiller and move the wine to a cooler location
until power is restored.

Preparing to Move

Unload the wine, then secure the racks by
taping them in place to prevent damage.
Unplug the wine center/beverage and wine center.
Remove any beverages and shelves as needed for access.
The light bulb is located behind a light shield in the ceiling of the wine
center/beverage and wine center near the back. To remove the light shield,
remove the screw on the right side of the light shield.
Pull down on the back of the light shield to release the two front tabs.
Unscrew the light bulb from the socket.
Replace with a 15 watt, 120 volt bulb. This type of bulb is available at most
hardware and automotive parts stores.
WARNING
the electronic controls on the wine center/beverage and wine center.
Reinstall the light shield.
Replace the top shelf and beverages.
Plug in the wine center/beverage and wine center
The controls may maintain your temperature
settings when the power has been restored. If
your settings are not correct, reset according
to the Control Settings section.
Be sure the beverage center/wine chiller stays in
an upright position during the move.
Using a bulb rated higher than 15 watts may damage
GEAppliances.com
9