Auto Code Search - Philips SRP2024A/27 Manual De Usuario

STR
DVD
Programming Your Remote
AUD

Auto Code Search

The Auto Code Search is a process where you can
search through all the codes stored in the remote
to find a code for your device. It is recommended
that you read through all the steps below to
familiarize yourself with the Auto Code Search
before starting the process.
CH
SLEEP
SETUP
INPUT
TV
STR
DVD
MENU
AUD
MENU
CH
SLEEP
D
SETUP
OK
EXIT
A B C
1. Manually turn on the device you wish
to control.
1 2
Note: The Auto Code Search process
cannot be used for devices without
4 5
power ON/OFF capability. Use the
Direct Code Entry method in these
7 cases. 8
2. Press and hold down the SETUP
0
(-)
button on the remote until the red
light on the remote control turns on.
Release the SETUP button. The red
light will remain on.
Note: The red light will either be a
small light at the top of the remote or
the power ON/OFF button.
3. Press and release the device button
on the remote for the type of device
you wish to control, (for example TV,
STR, DVD, AUD). The red light will
blink once and remain on.
OK
4. With the remote pointed at the
device, press and release the POWER
button on the remote. The remote will
send 10 different codes to the device.
The red light will blink once for each
code and remain on after sending the
EXIT
10 codes.
Did the device turn off?
• If YES, go to Step 5.
• If NO, repeat Step 4 to test the next
10 codes.
5. Manually turn the device back on.
A B C
6. With the remote pointed at the
device, press and release the VOL +
1 2
button.
4 5
7 8
(-) 0
D
3
6
9
ENTER
MENU
D
3
6
8
9
ENTER