Setup; Button Functions; Code Entry; Direct Code Entry - Philips MRU4100 Manual Del Usuario

Button Functions

Some buttons on the remote might have functions that
are referred to by different names on the device you are
controlling. E.G. PREV CHAN may be called RECALL,
or ENTER may be called DISPLAY. These differences
depend on the brand and model of your product. Also,
this remote can only operate features that exist on your
product. E.G., your product must have PREV CHAN
ability for the PREV CHAN button to operate this
feature.
CHANNEL UP/ Red Indicator
DOWN Lights when
Changes the any button is
channels. pressed.
MUTE Turns off the
TV sound while the
picture remains.
CC (Closed Caption)
TV Closed Caption
(if your TV has this
feature).
PREV CHAN
Returns to the
previously selected
channel.
CODE
SEARCH
Used for setup
NUMBERS
Enter numbers for direct
channel selection. Some
products require Enter to
be pressed after channel
selection.
ENTER
Used after direct
channel number
entry to immediately
change to the
selected channel.
MRU4100-OM(MX010)_H14112A.pmd
VOLUME UP/
DOWN Changes
the volume level of
the product,
normally the TV.
CHAN +
MUTE
CC
3
1 2
4 5 6
7 8 9
0
ENTER SLEEP
SLEEP Turns off the
TV after a period of 1
to 99 minutes.
4
4-5

Code Entry

Direct Code Entry

1. Press and hold the CODE SEARCH button until the
red indicator stays on, then release the CODE
SEARCH button.
2. Enter the 4 digit code from the code table. Note:
after a valid code entry, the red indicator turns off.
For an invalid code, the red indicator flashes.
3. With your device on, press CHANNEL UP. If the
device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
Write your code down here for easy reference later.
Code
Programming with Code Search
If your TV does not respond after you have tried all the
codes for your brand, or if your brand is not listed, try
searching for your code by following the steps below.
1. Manually turn on the TV to be controlled.
2. Press and hold the CODE SEARCH button until the
red indicator stays on, then release the CODE
SEARCH button.
3. Press the CHANNEL UP button repeatedly (up to
300 times) until the device to be controlled changes
channel. The red indicator blinks off with each
button press. If you accidentally overshoot the
code required, press the CHANNEL DOWN button
to backtrack through the library until the device
changes channel. Pressing CHANNEL UP changes
direction to forward again.
4. Press and release MUTE to install the code.
Note: Code Search starts from the currently stored 4
digit number.
10/12/2007, 3:47 PM
5