Ratio AR36-2NM Manual De Instrucciones página 37

RECHARGING
BATTERIES
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for driving in and
loosening screws.
1. RECHARGING BATTERIES
a) CHARGING THE BATTERY
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
b) IMPORTANT NOTES FOR CHARGING THE
BATTERY
The battery in your new Screwdriver is not
charged when it leaves the plant. Therefore it
must be charged before using the first time!
NOTE: If the battery pack is very hot you must
remove your battery pack from the charger and
allow your battery pack to cool first to ambient
temperature and then recharging can be started.
To prevent damage to the Battery Pack,
when charge runs out, charge the battery to
reach full or no less than half charge before
storage.
If the tool will not be used for long periods of
time, charge the battery every 3-6 months
c) CHARGING (SEE FIG. A)
A
• To charge your screwdriver, follow the steps
below. Plug charger plug into a suitable mains
socket and plug the output cord of the charger
into the socket of the screwdriver, the charging
indicator 6 (red) will illuminate at this time.
• After charging 3 to 5 hours, the battery will be
fully charged. When fully charged, the red light
will switch off. Unplug the charger plug from the
wall socket, the screwdriver is ready to use.
OPERATION
1. OPERATION INSTRUCTIONS
Inspect the screwdriver before using to ensure
all parts are running smoothly and there no
abnormal sounds or sparks. Before driving
fasteners, check behind walls for wire, other
electrical hazards or plumbing. Clear the work
area of all parts and debris that may cause injury
by flying objects. Securely fix the object to be
fastened in a vice or otherwise clamp to avoid
injury. Do not attempt to hold work piece by
hand.
2. FITTING AND REMOVING BITS (SEE FIG.B)
B
To use any one of the short bits, insert the bit into
the bit holder and push the holder into the chuck
as far as possible. To remove the bit, simply pull
it out of the bit holder.
NOTE: Always use a bit holder when fitting the
short bits!
3. FORWARD/REVERSE SWITCH (SEE FIG.C)
C
The screwdriver has forward/reverse function,
press the Forward/Reverse Rotation Switch (4)
in the left part, it is reverse function, then press
the Forward/Reverse Rotation Switch in the right
part, it is forward function.
WARNING:
Never change the direction of rotation when
the chuck is rotating. Wait until it has stopped.
4. ADJUSTABLE HANDLE (SEE FIG.D, E)
This machine can use as straight grip or pistol
grip.
37