Noise/Vibration Information; Declaration Of Conformity - Wurth Master S 50 TB Manual Original

Warranty
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth compressed-air and power tools.
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its in-
corporation into national law, power tools that are
no longer suitable for use must be separately collect-
ed and sent for recovery in an environmental-friend-
ly manner.

Noise/Vibration Information

Measured values determined according to EN 60 745.
The A-weighted noise level of the machine is typically:
Sound pressure level (L
Sound power level (L
Measurement uncertainty
The noise level can exceed 85 dB(A) during opera-
tion. Wear hearing protection!
) 78 dB(A)
pA
) 89 dB(A)
wA
K = 3 dB
Subject to change without notice
Vibration
Triaxial vibration emission value determined ac-
cording to EN 60745.
Screwing
Measurement uncertainty
The vibration emission level given in this information
sheet has been measured in accordance with a
standardised test given in EN 60745 and may be
used to compare one tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information
sheet. This could lead to underestimation of vibration
when the tool is used regularly in such a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is run-
ning but not actually when doing the job.
This may significantly reduce the exposure level over
the total working period.

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
EN 60745-1, EN 60745-2-2,
EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3 EN 62233
according to the provisions of the regulations
2006/42/EC, 2014/30/EU, 2011/65/EU,
1907/2006/EC, 2009/251/EC.
Technical file at:
Adolf Würth GmbH & Co. KG, Abt. PPT
Reinhold-Würth-Straße 12 - 17
74653 Künzelsau, GERMANY
Frank Wolpert
Head of Product
Management,
Authorized Signatory
Künzelsau: 13.06.2016
2
a < 2.5 m/s
h
2
K = 1.5 m/s
Dr.-Ing. Siegfried Beichter
Head of Quality,
Authorized Signatory
9