ELICA ELIBLOC LUX IX/A/60 Montaje Y Modo De Empleo página 13

Use
The hood is designed to be used either for exhausting
or filter version .
Operation
The hood is fitted with a control panel with aspiration speed
selection control and a light switch to control cooking area
lights.
1. Motor ON/OFF button
By pressing the button, the hood starts at speed 1.
Pressing the button (OFF) while the hood is in function
turns the latter off.
2. Speed increase button
By pressing the button, the hood starts at speed 1.
Pressing the button (while the hood is on) modifies the
motor speed:
Speed 1: the number "1" appears on the display
Speed 2: the number "2" appears on the display
Speed 3: the number "3" appears on the display
High-speed: the number "4" appears (flashing) on the
display
The high-speed function is regulated by a timer. The
standard time setting is 5', at the end of which the hood
adjusts to speed 2.
Press button 2 to deactivate this function before the set
time expires; the hood will adjust to speed 1. Press
button 1 to turn the hood off.
3. Lights ON/OFF button
4. Speed timer button
5. Display
Temperature Alarm
The hood is equipped with a temperature sensor which
activates the motor at speed 3 in case the temperature in the
display zone is too high.
The alarm condition is indicated by the display with the letter
"t" flashing. This condition remains as such until
the temperature falls below the alarm threshold. This mode
can be quit by pressing key "2". Every 30" the sensor checks
the ambient temperature of the display zone.
Speed timer button
Press button "4" to activate the speed timer; the hood turns
off once the set time expires.
The timer functions in the following way:
Speed 1 - 20 minutes (the number "1" and a small
•
flashing LED light appear on the display)
Speed 2 - 15 minutes (the number "2" and a small
•
flashing LED light appear on the display)
Speed 3 - 10 minutes (the number "3" and a small
•
flashing LED light appear on the display)
High-speed - 5 minutes (the number "4" and a small
•
flashing LED light appear on the display)
Press button 1 or button 4 to turn the hood off while the speed
timer is in function; by pressing button 2, the hood returns to
the set speed.
Saturation indicator of the grease filter
After 80 hours of operation, the display shows alternately the
set speed and the letter "F".
Saturation indicator of the charcoal filter
After 320 hours of operation, the display shows alternately the
set speed and the letter "C".
Reset of saturation indicator
In order to reset the saturation indicator, switch on the hood
then press and hold button 1for about 3 seconds.
Perform filter maintenance as recommended in this manual.
In the event that both indicators of filter saturation "F" and
"C" start flashing, proceed with the reset twice.
The saturation indicator of the charcoal filter is not normally
active and if the hood is used in the recirculation mode, it must
be activated manually the first time.
Activation of the charcoal filter saturation indicator:
Turn off the hood and simultaneously press buttons2 and 3 for
3 seconds.
The letters "F" and"C" will flash on the display for 2 seconds,
to indicate successful activation of the saturation indicator of
the charcoal filter.
Deactivation of the charcoal filter saturation indicator:
Turn off the hood and simultaneously press the buttons2 and
3 for 3 seconds. Only letter "F" will flash on the display for 2
seconds, to indicate successful deactivation of the saturation
indicator of the charcoal filter.
12