Mounting The Hood - arietta Segrino Guía De Instrucciones Para Instalación

For recessed bottom cabinet only
If the cabinets have front, side or back trim, make 2 wood shims the
width of the trim and attach them to the cabinet bottom recess on
both sides.
Wood shims
Outside rear exhaust
(Horizontal duct– 3 ⁄ "x 10" Rectangular)
1
4
Use the diagram or the hood as a template and mark the locations on
the wall for ductwork, electrical wiring and keyhole screw slots.
30": 13 ⁄ " (35.15 cm)
13
16
36": 16 ⁄ " (42.77 cm)
13
16
7" (17.7 cm)
⁄ " (1.5 cm)
39 1 ⁄ " (3.5 cm)
3
64
8
4 ⁄ "
21
64
(11 cm)
5
1
(14 cm)
2 ⁄ "
1
2
(6.3 cm)
10 ⁄ " (27 cm)
5
8
Permanent
Mounting hole
CENTER LINE
1. Remove the grease filters.
2. Remove the blower mounting screws. Put the screws in a
safe place in order to use them again.
3. Set free the two blower springs from the top of the range
hood housing.
4. Flip the blower base to the rear face of the range hood.
WALL
30": 13 ⁄ " (35.15 cm)
13
16
36": 16 ⁄ " (42.77 cm)
13
16
7" (17.7 cm)
39
⁄ " 5 ⁄ "
1
2 2
(14 cm)
10 ⁄ " (27 cm)
5
8
Permanent
Mounting hole
5. Insert the two blower springs to the top of the range hood
housing, secure it with the four mounting screws previously
released.

Mounting the Hood

Cabinet Installation
NOTE: Your cabinet must be able to support at least
88 lb (40 kg).
1. Drive a mounting screw (from the hardware package) partway
into each center of the narrow neck of the keyhole slots
⁄ " (1.5 cm)
64
marked on the cabinet bottom.
2. Install the 4 - 4 x 8 mm mounting screws. Leave a
(6.4 mm) gap between the wall and the back of the screw
head to slide range hood into place.
3. Fix the wiring conduit of the hood.
4. Slide the hood back against the cabinet. Tighten the
mounting screws. Be sure the screw heads are in the narrow
neck of the keyhole slot.
NOTE: You should consider the wall's construction material in
order to choose the right wall anchor and screw. For plywood
walls you should use the 10x60 mm wall anchors and the 5.4x75
mm screws. For concrete walls you should use the 8x40 mm wall
anchors and the 5x45 mm screws
5. Drive 2 pieces of the selected screws and washers in the
security holes (See the image below).
A
6
⁄ "
1
4
(6.4 mm)
B
C
A. 4- 4x8 mm Mounting Screws
B. Washers
C. Security screws
⁄ "
1
4