Helios Prox Control Unit Control Unit For Sunshades - Helios PROX Manual Del Usuario

1. Introduction
HELIOS PROX control units are universal devices suitable to handle the activation and the control of sunshades in a simple and complete way ,
designed to meet any sort of requirements. This product controls 230V motors in alternating current up to 500 W (max) power supply and is
provided with automatic limit switches with maximum opening time of 7 minutes. HELIOS PROX control unit uses the innovative rolling code
decoding system: this choice makes it safe, easily expandable and its installation is quick and intuitive. In each HELIOS PROX device is installed
an extractible memory which can memorize up to 8000 different transmitters. The logic of the HELIOS PROX offers the possibility to act:
•
the specifications detected by the anemometer (code 12001710 WIN EX – code 12001705 WIN S – code12001712 WIND DUO) relative
to the velocity of the wind.
•
the intensity of the light by the light sensor (code 12001850 LUX – code 12001712 WIND DUO)
•
information taken over the rain sensor (code 12001840 RAIN)
•
the position of the partial opening of the sunshade
These controls allow to HELIOS PROX to open and/or close the sunshade in a completely automatic way, according to the atmospheric
conditions present in that moment.
2. Configuration
Led learning/alarm
Led manual mode
Led external light
detected
3. Electrical connections
WIND
SENSOR
6-1621095 rev.9 19-07-2012
HELIOS PROX control unit
Control unit for sunshades
Dip - switch
Extractible
memory
Radio module
Exp. Exp.
Exp.
RAIN
SENSOR
LIGHT
SENSOR
EXTERNAL POWER
SUPPLY 12 Vac / dc
for heater
ITA
Jumper
WIN S: - BLU cable on input nr. 1 terminal board
WIN EX: - WHITE/BLUE cable on input nr.1 terminal
LUX: - Connect the terminal board nr.1 of the light
ENG FRA ESP DEU POR
Learning key
Trimmer for the regulation
of the wind alarm threshold
Jumpers for the
enabling of the
clean contacts
Connections wind sensor
HELIOS PROX
- BROWN cable on input nr. 4 terminal board
HELIOS PROX
board HELIOS PROX
- GREEN/BROWN cable on input nr. 4 term.
board HELIOS PROX
Connections light sensor
sensor to the terminal board 1 of the control unit
HELIOS PROX
-Connect the terminal board nr. 2 of the light
sensor to the terminal board 7 of the control unit
HELIOS PROX
9 / 32