Idiomas disponibles
Idiomas disponibles
B.
UNPACKING
After unpacking the light, inspect it for damage that may have occurred in transit.
If the unit has been damaged, do not attempt to install or operate it. File a claim im-
mediately with the carrier, stating the extent of damage. Carefully check all envelopes,
shipping labels, and tags before removing or destroying them.
C.
KIT CONTENTS LIST
Qty.
Description
4
#8 x 1-1/2" Screw, S.S.
4
Screw Grommet
D.
INSTALLATION
When installing equipment inside airbag equipped vehicles, the
installer MUST ensure that the equipment is installed ONLY in areas
recommended by the vehicle manufacturer.
Failure to observe this warning will reduce the effectiveness of the
airbag, damage the air bag, or potentially damage or dislodge the
equipment, causing serious injury or death to you or others.
For maximum coverage and effectiveness, the light assembly must be mount-
ed in a horizontal orientation (see Figure 1).
Before proceeding with installation, determine the approximate location of
the light assembly and plan all cable/wire routing.
1.
See Figure 1. Position the QuadraFlare LED Scene Light assembly on the de-
sired mounting surface. Ensure that the unit is level side to side. Using the dimensions
provided in Figure 2, scribe the four mounting hole locations and a wiring routing hole
location on the mounting surface.
Before drilling holes in ANY part of a vehicle, be sure that both sides of the
mounting surface are clear of parts that could be damaged; such as brake
lines, fuel lines, electrical wiring or other vital parts.
2.
Drill four 1/4" (0.250) mounting holes and a wire routing hole 1" (1.00) at the
previously scribed locations.
3.
Install the four supplied screw grommets into the four 1/4" mounting holes.
All drilled holes should be free of burrs and sharp edges. All wire routing
holes should be grommeted (user supplied) and/or sealed to avoid wire and/or
vehicle damage.
Part No.
7011238-24
7065073
NOTE
-2-
