Assembling & Adjusting Connecting Rod Length; Attaching Connecting Rods - Fanimation Punkah Manual Del Propietário

Assembling & Adjusting Connecting Rod Length
1. Loosen each of the "outer" set screws on the outer rod
assembly.
2. Insert each "inner" rod assembly (2 pcs) equal
amounts so that the distance between connecting rod
end holes is equal to the distance between the center of
the motor shaft and center of the blade holder or same as
the distance between blade holder to blade holder.
3. Tighten set screws so that ends are perpendicular to
each other for motor to blade holder application.
Tighten set screw so that ends are parallel for blade
holder to blade holder applications.
4. For lengths shorter than 24 inches loosen set screws,
remove couplers and cut outer rod, then cut 1/2 the
amount removed from the outer rod from each of the
inner rods.
Replace couplers and repeat steps 1 through 3.
Option 1 - Single Linkage Confi guration (Figure 14a)
Option 2 - Double Linkage Confi guration (Figure 14b)
Motor End
1. Place Socket head screw through connecting rod end
and supplied hardware to match your application.
2. Tighten screw into motor link.
3. Secure locking nut to top of motor link to prevent bolt
from loosening.
4. Slide motor link over motor shaft and tighten socket
head cap screw to secure link to shaft.
NOTE: Ensure that screw is positioned over flat on shaft
prior to tightening screw.

Attaching Connecting Rods

9
Coupler
Outer Rod
Loosen setscrew for
inserting/adjusting
rod lengths
Figure 13
Socket Head
Screw - 1¾
Nylon
Washer
Spacer
Motor
Link
Lock Nut
Socket Head Cap
Screw
Figure 14a
Allen Wrench
Socket Head
Screw - 2¼
Nylon
Washer
C-Rod
Nylon
Washer
Spacer
Motor
Link
Lock Nut
Socket Head Cap
Figure 14b
Screw
Allen Wrench
Inner Rod
˝ long
Connecting
Rod Assembly
˝ long
Connecting
Rod Assembly