Performance Chevrolet Camaro SG3 Instrucciones De Instalación página 12

Rear Coil Spring Lower Insulator (reuse)
1
When installing the lower insulator on the coil spring, ensure that the insulator stop is against the last coil on
the spring.
Rear Coil Spring (replace with SG3 spring)
When installing the coil spring, ensure that the coil spring is properly seated in both insulators.
2
Note: The spring tag should be on the top side of coil spring, toward the upper insulator for correct installation
of the coil spring and insulators.
Rear Coil Spring Upper Insulator (reuse)
3
When installing the upper insulator on the coil spring, ensure that the insulator stop is against the last coil on
the spring.
Caution: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener
when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or
component.
1. Using adjustable stand or jack for alignment; Install the rear suspension lower control arm inner Nut (1), Bolt (2) and Cam
Washer (not shown) >> Install Supplied New Bolt, Cam Washer and Nut.
Chevrolet Camaro SG3 Sport Suspension
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Rear Spring
(Driver and Passenger Side Spring)
REV 01JN16
DATE
10AU15 Initial Release - Thomas Gierman
01JN16 Revision - Andrew Rogers
84188729
PART NO.
REVISION
12 48
SHEET OF
AUTH
2117284
2484395