Health O Meter Professional PROPLUS Instrucciones De Uso página 6

ASSEMBLY INSTRUCTIONS (CONTINUED)
Scale - Opening and Assembly Instructions:
1. Open the scale and place it upside down on a level floor.
2. Twist in the eight plastic feet assemblies completely onto the bottom of the scale; do not tighten. Back each foot out 1-1/2 turns, to avoid over tightening the feet.
3. Turn the scale assembly right side up on its feet.
4. Tighten the locking knob located on the carrying handle.
NOTE: For accurate weighing, the locking knob must be completely tightened.
5. Make sure that all scale parts are leveled at least ½‖ from the floor (pay special attention to
the two folding hinges in the center). If necessary, raise the scale by adjusting all eight feet.
6. Bring the wheelchair close to the scale ramps. Loosen the width adjusting knob; adjust the
scale width by moving the left ramp. NOTE: Often front and rear wheels on wheelchairs are
not perfectly aligned. Make sure that both front and rear wheels of the wheelchair in use are on
the scale ramps.
7. Tighten the width adjusting knob in order to lock the width adjusting mechanism.
Figure 2a
6
Figure 2b