Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Custom Wood Panel Installation
NOTE: For instructions to install a Voxtorp kitchen door front,
go to the "Voxtorp Kitchen Door Front Installation" section.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1.
Stand dishwasher upright
Using 2 or more people, stand the dishwasher up.
NOTE: Do not install kick plate until instructed to do so in the
dishwasher Installation Instructions.
2.
Attach handle
Install the custom hardware handle(s) on the front of the wooden
panel inside dotted line.
IMPORTANT: If the handle is attached from the back of the
custom panel, the screw holes should be countersunk for the
screws heads to be flush with the panel. If the handle is attached
to the front of the custom panel, the screw lengths cannot
exceed the panel thickness.
2
6"
(15.2 cm)
3.
Panel template
Wood Panel Template
Centerline
W10195005A
Using the template provided, attach it to the backside of the
custom panel with tape. Make sure that the center of the
template is aligned with the center of the wooden panel and top
of the template is aligned to the top face of the wooden panel.
4.
Predrill custom panel holes
NOTE: Do not drill deeper than
drilling through panel. Pilot hole depths given are for
(19 mm) thick panel.
Mark 4 pilot holes on the wooden panel using the template
provided. Predrill 4 pilot holes using a
to mark the drill bit to gauge hole depth. Drill pilot holes
approximately
/
" (16 mm) into the custom panel.
5
8
Top of panel
Pilot
holes
/
" (16 mm) to keep from
5
8
/
"
3
4
/
" drill bit. Use tape
3
32
Tabla de contenido
