Important Safety Instructions; General Safety - Eco-Flo EFCWJ5-A El Manual Del Propietario

STOP Before you start
Fill Pump with water tto prime: Ensure pump body is filled with
water to discharge.
Motor's Electrical Settings: Set motor to proper voltage,
Help Line: Call 1-877-326-3561 for assistance

Important Safety Instructions

Carefully read and follow all safety
instructions in this manual and on pump.
SAVE THESE INSTRUCTIONS – This manual
contains important instructions that should be
followed during installation, operation, and
maintenance of the product. Save this manual for
future reference.
Safety Labels
This is the safety alert symbol. When you
see this symbol on your pump or in this manual,
look for one of the following signal words and be
alert to the potential for personal injury!
Indicates a hazard which, if
not avoided, will result in death or serious injury.
Indicates a hazard which,if
not avoided, could result in death or serious injury.
Indicates a hazard which,if not avoided, could result in minor or moderate injury.
NOTICE
indicates practices not related to
personal injury.
Keep safety labels in good condition. Replace
missing or damaged safety labels.
Under certain conditions,
submersible pumps can
HAZARDOUS PRESSURE
develop extremely high
pressure. Install a pressure relief valve capable of
passing entire pump flow at 100 PSI (690 kPa).
Do not allow pump, pressure
tank, piping or any other
system component containing water to freeze.
Freezing may damage system, leading to injury
or flooding. Allowing pump or system compo-
nents to freeze will void warranty.
For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561

GENERAL SAFETY

HAZARDOUS VOLTAGE
hazard, use pump only in a water well.
Do not install this pump in a pond, river or other
open body of water that could be used for swim-
ming or recreation. Do not swim, wade or play
in a body of water in which a submersible pump
has been installed.
Canadian Electrical Code or National Electrical
Code requirements that apply.
servicing pump.
frequency.
Install pump according to all plumbing, pump
and well code requirements.
Test well water for purity before using well. Call
your local health department for testing proce-
dure.
During installation, keep well covered to prevent
leaves and foreign material from falling into the
well. Foreign objects in well can contaminate
water and cause serious mechanical damage to
pump.
Pipe joint compound can cause cracking in plas-
tics. Use only teflon tape when sealing joints in
plastic pipe or connecting pipe to thermoplastic
pumps.
2
Can shock, burn or cause
death. To avoid dangerous
or fatal electric shock
Install ground and wire
pump according to local and
Disconnect electrical power
supply before installing or
Make sure line voltage
matches pump voltage and