Scope Of Delivery - Goobay 67000 Manual De Instrucciones

User manual
EN
SAT Finder with mechanical display | SAT Finder with digital display
1 Safety Instructions
• Read the user manual completely and carefull before use.
It is part of the product and contains important information for correct use.
• Keep this manual.
It must be available for uncertainties and passing the product.
Product:
• Keep yourself safe at the product's set-up location
(i.e. watch out for slippery rooves, danger of falling)
• Install the system and devices attached to it in a way that
persons cannot be injured, or objects not be damaged for
example by dropping or stumbling.
• Do not use the device directly in front of the dish to avoid a
wrong signal.
• Use a 5dB attenuator in the case of a LNB gain higher than 60dB.
• Do not place any objects on the device.
• Do not install the product close to openings of air conditio-
ners, or at places with an excessive amount of dust or smoke.
• Do not modify or alter product nor accessories.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against acci-
dental use.
• Avoid stresses such as heat and cold, moisture and direct
sunlight, vibration and mechanical pressure.
• In case of questions, defects, mechanical damage, trouble
and other problems, non-recoverable by the documentation,
contact your dealer or producer.
• Do not permanently install device between the satellite dish
and the receiver!
Continuous operation can damage the product.
• NEVER leave unattended while in operation.
• For industrial facilities, the accident prevention regulations of
the Health and Safety Executive for electrical systems and
equipment must be observed.
• Please also observe the safety instructions and operating
instructions of the other devices connected to the product.
• Do not open the housing.
• For questions, defects, mechanical damages, malfunctions,
and other functional problems which cannot be resolved by
this guide, please contact your dealer or producer.
• Only use in dry ambience.
Risk of injury by stumbling and falling.
2 Description and Function
2.1 SAT Finder
This product is used to align your satellite dish for optimal reception. The
SAT Finder shows the signal strength of the satellite in the display. The
Model 67000 has an illuminated display. The Model 67140 has an illu
minated LCD display with digital indication of the field strength of the
satellite signal and additionally generates an acoustic signal, which gets
louder the better the signal is.
2.2

Scope of Delivery

Article-No. Scope of Delivery
67000 SAT FINDER analogue, F-connection cable, User manual
67140 SAT FINDER with digital LCD, F-connection cable, User manual
REV2020-10-01
V3.1 ir
Subject to change without notice.
2.3 Controls and Parts
67000
1 Connection to the LNB 2 Frequency display
3 Voltage indicator 4 analogue display
5 Signal strength adjustment 6 Connection to the SAT receiver
7 F-connecting cable
67140
1 Connection to the LNB 4 LCD display
6 Connection to the SAT receiver 7 F-connecting cable
8 ATT: Signal reduction of the input signal
9 Light 10 Compass
11 Buzzer control 12
13 Volume control
3 Intended Use
We do not permit using the device in other ways like described in chapter
"Description or Function" and „Safety Instructions". Not attending to these
regulations and safety instructions might cause fatal accidents, injuries,
and damages to persons and property.
4 Preparing
• Check the scope of delivery for completeness and integrity.
5 Connection and Operating
1
1. Connect the coaxial cable coming from LNB to the satellite
socket (1) of the SAT Finder.
2. Connect the coaxial cable of the receiver input to the receiver
connector (6) of the SAT Finder.
3. Switch on the SAT receiver. The SAT Finder starts automati-
cally because it is powered by the SAT Receiver.
4. Align your satellite dish with the approximate azimuth angle
(horizontal angle) and the approximate elevation angle (ele-
vation angle).
Only 67140:
5. Turn the volume control (13) fully to until a maximum signal
strength is displayed.
6. Increase the signal by slowly moving the satellite dish
horizontally and vertically. The higher the display, the better
the signal.
When the SAT Finder receives the full signal, you can fine tune the signal
strength setting (5) on the Model 67000 or press the
on the Model 67140 to reduce the input signal.
7. Move the satellite dish again to the largest possible display
and the loudest beep.
67000 and 67140
8. Amplify the input signal with the Model 67000 signal strength
setting or the Model 67140
9. After adjustment, disconnect the product from the LNB and
receiver.
10. Reconnect the LNB to the SAT receiver after alignment.
- 2 -
6 Maintenance, Care, Storage, Transportation
The products are maintenance-free.
•
•
•
•
•
7 Disposal Notes
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its components
ATT: Signal amplification of the must be recycled or disposed apart from each other. Otherwise contami-
native and hazardous substances can damage the health and pollute the
input signal
environment.
As a consumer, you are committed by law to dispose electrical and
electronic devices to the producer, the dealer, or public collecting points
at the end of the devices lifetime for free. Particulars are regulated in
national right. The symbol on the product, in the user`s manual, or at the
packaging alludes to these terms. With this kind of waste separation,
application, and waste disposal of used devices you achieve an import-
ant share to environmental protection.
WEEE No: 82898622
6
ATT button (8)
ATT button (12)if it is too weak.
67000, 67140
Clean only with a dry, soft cloth.
Do not use cleaning agents and chemicals.
Store cool and dry.
Store the product out the reach of children and in a dry and
dustprotected ambience when not in use.
Keep and use the original packaging for transport.
Goobay
by Wentronic GmbH | Pillmannstraße 12
38112 Braunschweig | Germany
®