Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Models
WC 35
WC 44
WC 46
WC 50
Circle the model of your cooler and
record the serial number below.
Encierre con un circulo el modelo de su
enfriador y escribe el número de serie abajo.
Serial #
Número De Serie
Read Carefully All Of This Manual
Before Installing The Unit.
Read And Save These Instructions
Vea el Español en el interior
Evaporative Cooling
Evaporative cooling is nature's way of cooling. When air is moved
over a wet surface, water is evaporated and heat is absorbed. When
stepping out of a swimming pool with the wind blowing, evaporative
cooling makes you feel cool, even though the air may be warm. The
human body itself is cooled primarily by the evaporation of
perspiration.
This unit works on the same principle. Air is drawn across wet
filter pads where the air is cooled by evaporation and then circulated
throughout the building. It is this combination of cooled air and the
movement of air over the skin which makes it feel cool.
Unlike refrigeration systems which recirculate the air, an evaporative
cooler continually brings in fresh air while exhausting old air. You
are completely replacing the air every 2 to 4 minutes by opening
windows or doors or a combination of both. The air is always fresh,
not stale, laden with smoke and odors as happens with refrigerated
air conditioning.
110496-1
C H A M P I O N • M A R Q U I S
EVAPORATIVE COOLER
RWC35
RWC46
RWC50
www.championcooler.com
Lea Con Cuidado Todo Este Manual Antes
De Instalar La Unidad.
Safety Rules
1. Read these instructions carefully.
2. Electrical hook up should be done by a qualified electrician, so
that all electrical wiring will conform to your local standards.
3. Unit must be in the Off Position and Unplugged from power
receptacle when installing or performing any maintenance.
4. This cooler will run on 120 volt A.C., 60 Hz (cycle) current only.
5. Motor and pump are grounded and have an automatic thermal
overload switch which will shut motor off when it overheats.
The motor will restart automatically when it cools down.
6. Pump receptacle is for grounded evaporative cooler pump only.
Do not plug anything else into receptacle.
WARNING
: To reduce the risk of fire or electric shock, do
not use this fan with any "solid-state fan speed control device."
3-05
Tabla de contenido
loading

Resumen de contenidos para Champion MARQUIS WC 35

  • Página 8: Reglas De Seguridad

    Lea y Conserve Estas Instrucciones • Los posiciones HIGH COOL y LOW COOL. Ajuste el inte- rruptor a la posición HIGH COOL o LOW COOL para poner en marcha el ventilador a una alta o baja velocidad junto con la bomba. Reglas De Seguridad Ajuste el interruptor a la posición LOW COOL cuando posible.
  • Página 9: Instalar El Enfriador

    El método siguiente le ayudará. unidad (A-fig. 3). Engan- che una cadena en cada El Método De Champion De Equilibrar El Aire gancho y luego enganche Gancho “S” un gancho “S” en cada ca- dena.
  • Página 10: Conectar El Agua

    • Coloque la ventana detrás de la guarda de retención. Levante • Limpie la bomba. Es necesario limpiar la bomba una vez al la parte trasera del enfriador para que la ventana (D-fig. 3) pueda principio de cada año. Por su propia seguridad, apague la unidad bajarse y quedar detrás de la parte superior de la guarda de reten- y desconéctela de la electricidad.
  • Página 11: Esquemas Del Cableado

    Alinee A Los Dos 6. Alinee los tres agujeros en Conversión Al Conducto Vertical Agujeros Medios el fondo del conducto con los agujeros en el panel de- Esta unidad se puede configurar de nuevo a una configuración con el lantero. Con los tornillos conducto vertical para la instalación en una abertura más pequeña de quitados del conducto pre- la anchura.
  • Página 12: La Localización De Averías

    Durante Ocho Años a partir de la fecha de compra, nosotros reemplazaremos la base original del enfriador en caso de que goteara agua debido a oxidación. Durante Un Año a partir de la fecha de compra, reemplazaremos cualquier componente original proporcionado por Champion Cooler que falle debido a cualquier defecto de material o mano de obra en la fábrica solamente.

Tabla de contenido