Health Zenith DualBrite Manual Del Usuario página 2

INSTALLATION
For best performance, mount the fixture
about 6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit
breaker.
1. Remove
two nuts.
SENS
MIN
MAX
4. Set sensitivity con-
trol on back of fixture
to mid-position.
Attach mounting
5.
plate to junction box.
Horizontal Junction Boxes Only:
Fixture
Screw
Junction
Screws
Remove ground screw and 2 fixture screws
from the mounting plate. Flip plate over.
Re-insert ground screw. Insert the 2 fixture
screws in the holes near the junction box
screws holes. Wire path must be located
as shown above.
2. Remove
Mounting Plate.
3. Tighten screws
finger tight.
Ground Screw
Wire Path
Ground
Screw
Wire
Fixture
Path
Screw
Box
WIRING
BLACK
WHITE
One Motion Light
BLACK
WHITE
Two Motion Lights
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green "pigtail".If you are unsure about
the grounding method, consult your local
building code.
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Recommended Grounding Method
Use a green ground "pigtail" (not provided)
and twist one end together with the bare
fixture wire and the box ground wire.Secure
with a wire connector.Secure the other end
of the "pigtail" with the GND screw on the
mounting plate.
Black to black
2
BLACK
White to white
595-5578-08