Simu T5E-SP Traducción Del Manual Original página 5

2
Adjustment of end limits
During the end limits adjustment, there is a one-second delay in motor operation.
2.1. Connect the motor to the settings switch
(ref.: 2006024). This switch is specific to T5E / T5E-SP
/ T6E-SP motors. Do not under any circumstances
use it with another motor!
2.2. Check the rotation direction:
Connect the switch to the mains, then press
a. If the tube turns in the "up" direction, go to step 2.3.
b. If the tube turns in the "down" direction, invert the brown
(2) and black (3) wires on the motor, and repeat the test.
2.3. Opening the end limit setting mode:
- Press simultaneously on
other*. Go to step 2.4.
2.4. Initializing obstacle detection:
- Press on for 3 seconds. The motor will run briefly in one direction and then in the other*. Go to step 2.5.
▲
2.5. Adjustment of down end limit:
- With the T5E-SP / T6E-SP motor, there is no manual adjustment for the upper
end limit.
a. Position the motor on the desired down end limit using the
b. To memorize the down end limit, press
1st press for half a second without the motor rotating.
2nd press over 3 seconds, so the motor rotates briefly one way, then the other*.
2.6. Validation of end limits:
- Press the and keys simultaneously for at least 3 seconds. The motor briefly rotates one direction and
▲ ▼
then in the other*.
- The settings are now complete. There is no delay time any more in motor operation. You can now connect the
motor to the final reversing switch (§3).
* Press the buttons until the motor turns into the two directions.
5
2
▲
and for 3 seconds. The motor will run briefly in one direction and then in the
▲ ▼
twice:
▲
Ø4,8 x 10
STEEL
Ø5 x 10
9910062
4
3
Blue
Brown
Black
Green/yellow
a
:
>>
and
▲ ▼
1
PE
L
N
b
OK
a
b
>>
0,5s
6s max.
3
2 4
1
2
>>
3
>>
3s
>>
3s
+ >>
3s
>>
3s
2/3