Whirlpool ACO 035 Instrucciones De Utilizacion página 7

Part of this humidity must be considered normal were the products are not wrapped or if they are inside containers without lid;
•
It can be cause by frequent opening or long opening of the door. Check if the door close properly.
•
IF THE INCONVENIENCES WILL NOT STOP PLEASE CONTACT THE NEAREST ASSISTANCE-SERVICE CENTRE
ATTENTION THIS OPERATION MUST BE DONE ONLY BY AUTHORISED TECHNICAL SERVICE OR QUALIFIED PERSONNEL
A INSIDE LAMP
1. Remove the plug from the socket;
2. Take off the lamp-lock from its seat with a screwdriver;
3. Take off the light screen making it move on the right and then gently press it downward;
4. Replace the light
5. Invert the operation order to place the light
B CANOPY LAMP
Remove the plug from the socket;
•
Unscrew the fastening screws to take off the canopy
•
Replace the light
•
Invert the operation order to place the light
•
TO AVOID POTENTIAL HAZARDS, DAMAGED POWER CABLES MUST BE REPLACED BY THE MANUFACTURER, THE MANUFACTURER'S
SUPPORT SERVICE, OR A SUITABLY QUALIFIED TECHNICIAN.
When the cabinet will not be used for a long time, please proceed as follows:
Before the standing period:
Take the plug off the socket;
•
Defrost clean and dry the inside and outside of the cabinet;
•
Leave the glass door open to avoid possible formation of bad smells;
•
Cover the cabinet with a curtain, place it in a dry room and repaired from atmospheric agents;
•
When the cabinet will be started up again:
Repeat the electric checking given in PUTTING INTO OPERATION;
•
Wait for two hours at least before putting the products inside.
•
On the front top of the cabinet there is the control panel with switchers and control lights
(1) Lights switcher:
Switching it on you light the inside lamp (for the model with the canopy it also light it).
(2) Thermometer
The inside temperature is indicated on the horizontal reading thermometer
(3) Thermostat
To regulate temperature use the hand thermostat that is on the control panel.
Turning it left you rise the temperature turning it right you fall it.
(4) Electrical thermostat
Only when present. For details, see booklet attached for the directions of use of the thermostat.
Warning: the following procedure is to be performed only by an specialised technician.
R
EMEMBER TO REQUEST THE SPECIAL
HOW TO REPLACE THE LIGHTS
7 S E A S O N A L U S E A N D / O R N O N – U S E
8 S E T T I N G A N D C O N T R O L S
9 D O O R O P E N I N G I N V E R S I O N
D R K
OOR EVERSE IT FROM THE MANUFACTURER
.